When the weather temperature is higher, the TPE particles tend to agglomerate. When using TPE compounds, the problem of particle agglomeration is more or less encountered. After the product is processed and packaged and stored, it will stick together, especially in the hot summer, there will be a high probability of clumping. So how to prevent the agglomeration of TPE material particles? What are the precautions? Today, Xiaobian will give you a specific explanation.

Precautions for preventing agglomeration of TPE material particles:

1. The problem of particle agglomeration may occur in transparent TPE materials, and a certain anti-sticking agent can be added before the particles are packaged and packaged to improve the agglomeration problem.

2. During injection molding production in the factory, if the agglomeration of TPE is serious, manual separation takes time, which affects the production situation. All the agglomerated materials can be broken into small pieces by a crusher, which is convenient for cutting and cutting.

3. For the problem of particle agglomeration that may occur in opaque TPE materials, some kind of anti-blocking agent can be added before particle packaging and packaging to improve the agglomeration problem.

4. In the hot summer, the TPE injection molding factory should pay attention to store the material particles in a cool place, and the air conditioner can be turned on when conditions permit. Try not to directly touch the finished product packaging, and do not store it under pressure to prevent the product from sticking and affecting the quality of the product.

5. TPE products should pay attention to the possible container temperature when the goods are exported. (The temperature of the container will gradually rise due to the accumulation of heat during the transportation process, and it may reach 60~70℃ sometimes.) It is expected that precautionary measures will be taken, and if necessary, a holding cabinet can be used.

Today's content will be shared with you first. Don't set the temperature too high when baking materials, especially some materials with low hardness, which are easy to cause agglomeration. There are also some customers who use TPR materials for toughening. Because the hard plastic will bake the material and the bucket is relatively high, we recommend that customers do not dry the TPR toughening agent and the hard plastic colleagues. They can first bake the hard plastic and then add the toughening agent and stir evenly for direct production.